Ramsey Winch H 700 DOW-LOK W/ COUNTERBALANCE VALVE, LESS BRAKE User Manual
Page 11
(7)
Check for signs of wear on gear teeth. If necessary replace
gear.
(8)
If shaft or gear is damaged, replace as follows:
a. Tap keys (item #17) into short keyways of drum shaft.
b. Press shaft (item #18) and keys through gear (item
#13) until end of keys on long end of shaft are flush
with hub.
(9)
Check gear housing bushing (item #5) and o-ring (item #52) for
signs of wear. Replace if necessary by pressing old bushings
from gear housing (item #14). Press new bushing into place and
insert new o-ring (item #52) into groove inside of bushings.
18
17
13
52
5
14
(10)
Check drum bushings (items 27 & 28) for signs of wear. Replace
if necessary by pressing old bushings from drum (item #12).
Press bushing (item #27) into bore in drum until the flange is
seated against bottom of counterbore. Press bushing (item #
28) into opposite bore on drum until end of bushing extends .50”
from end of drum.
27
12
28
9