Ramsey Winch HD-P8000 FOR NRC User Manual
Page 14
40
24
41
42
21
14
24
23
25
27
22
18
35
45
Insert springs (item #40) into pockets in back of brake piston. The two empty pockets should be on opposite sides.
Install roll pin (item #35) into new motor coupling below bottom of spline teeth. Insert motor coupling (item #23),
engaging it with the discs and the input shaft.
Place gasket (item #25) on mounting surface of motor (item #27). Slide motor shaft into coupling. Attach motor to
motor end bearing housing using (2) capscrews (item #18) and (2) lockwashers (item #22). Evenly tighten to 49 ft-
lbs. (66 Nm) torque.
Install the counterbalance valve (item #42) to the motor using (4) capscrews (item #14) and (4) lockwashers (item
#21). Tighten to 17 ft-lbs (23 Nm).
Securely connect fittings (item #24) to motor end housing and counterbalance valve, and connect tube assembly
(item #41) to fittings.
Apply at least 550 PSI hydraulic system pressure to brake and verify that brake releases (winch drum will rotate).
12