Ramsey Winch Powermaster Series 20K Bumper and Winch - Manual (Page 8)

6 OM-914206-1208-B
INSTRUCTIONS FOR DISASSEMBLY
1. NOTE: Removal of winch from bumper will require 2 persons. Winch must be lowered
through the bottom of bumper. Do not attempt to lift winch out through the top of
bumper.
2. To remove the winch from the bumper, it will be necessary to first disconnect the capstan drive
shaft # 105 from the winch by removing (1) 5/8-11UNC capscrew #109. Pull capstan drive
shaft out through hole in end of bumper. If it is necessary to remove the pillar block # 104,
remove (2) capscrews # 110 from front and (2) capscrews #110 from back side of bumper,
pillar block can then be removed from the underside of the bumper.
3. NOTE: Winch must be supported prior to removing winch mounting bolts.
4. Remove (6) capscrews #110 from back side of bumper as shown below. Next remove (4)
capscrews # 111 from back side of bumper. Remove (4) capscrews #108 from front side of
bumper. Once these capscrews are removed, the winch can be removed from the underside of
bumper.
110
109
104
105
101
106
101
106
108
110
108
111
110
111