Ramsey Winch RPH-20000 (RAMSEY GBX) - Manual (Page 13)

10.Place (2) gear carrier assemblies (with separater washer in between) into ring gear meshing car-
rier gears with ring gear. Place primary sun gear into primary carrier assembly. Apply a small
amount of grease to cover thrust washer and place on backside of cover. Apply RTV sealing
compound to cover mounting surface of ring gear and attach cover to ring gear. Use (8) cap-
screws (item #15) to secure gear box to gear housing end bearing. Torque capscrews to 18 ft.
lbs. each, in criss-cross pattern.
11. Pull rod from air cylinder as far as possible. Slide washer (item #25) over setscrew (item #22)
and against nut attached to air cylinder rod. Place setscrew into hole of shifter shaft (item #13-
shown above). Attach new air cylinder (item #30) and gasket (item #32) with sealer, to gear
housing cover using (4) capscrews (item #23). Torque capscrews to 5 ft. lbs. each, in criss-cross
pattern.
10