Ramsey Winch RPH-45000 (Foot Mtd.) - Manual (Page 14)

11
12. Gently tap key #5 into keyway of input shaft #11. Liberally apply grease to shoulder of input shaft.
Place 1-3/4 OD washer #28 over end of shaft and against shoulder of shaft. Place spring #44
inside of spring #45 and place both springs over shaft and against washer #28. Slide 2-3/8 OD
clutch washer #25 over splined end of shaft and against springs. Use grease to hold springs and
washers in place on shaft. Place splined end of shaft through drum and into output coupling #6.
Mesh spline of input shaft with internal spline of coupling shaft inside of drum.
Align keyway of coupling #8 with key on end of input shaft. Slide coupling over end of shaft #11.
Place gasket #35e into position on motor mounting surface of end bearing #9. Use (2) screws #19
to attach brake adapter plate #35d to motor end bearing. Torque capscrews to 85 ft.-lbs. each.
Place second gasket #35e on adapter plate. Insert brake shaft with key into coupling. Re-attach
brake assembly to adapter plate using brake assembly screws #16. Torque capscrews to 97 ft.-
lbs. each.
Note: Care must be taken to assure brake assembly and adapter plate are seated properly prior to
installing assembly bolts #16. Damage will occur to rotor stack or shaft snap ring if not properly
installed.
13. Attach motor #40 with well-oiled gasket #35b to
brake assembly #35. Use (2) capscrews #20
and torque to 74 ft.-lbs. each. Attach elbow #32
to bottom of valve #47 and fitting #33 to bottom
of brake assembly #35. Securely connect tube
#46 to elbow and fitting.
47
35
20
40
20
46
35b
25
45
44
28
5
16
19
19
35e
35d
35e
33
35c
16
8
9
11
35a