Re-assembly – Ramsey Winch RPH-50000 (Foot Mtd.) User Manual
Page 12
9
RE-ASSEMBLY
8. NOTE: DETERMINE MOUNTING CONFIGURATION OF WINCH (R.H. or L.H. MOUNTED)
BEFORE ATTACHING TIE BARS TO WINCH, TO ASSURE PARTS ARE MOUNTED TO
PROPER SIDE, REFER TO WINCH MOUNTING CONFIGURATIONS ON PAGE 13
.
Seat well-oiled quad-ring #41 into groove of bushing in each end of drum assembly #1. Carefully
set drum assembly down over motor end bearing #9. Lift gear-housing end bearing #10 and set
into place on drum assembly. Attach tie bars #2 and #3 using (8) capscrews #17 and lockwashers
#24. Install (4) shoulder bolts #29 and hand tighten. Tighten (4) innermost capscrews securely,
check rotation of cable drum. Tighten (4) outer-most capscrews securely, check rotation of cable
drum. Torque capscrews, in innermost then outer-most pattern shown below, to 430 ft.-lbs. each.
Torque shoulder bolts to 30 ft-lbs. each. Check rotation of cable drum assembly. It must rotate
freely with no tight spots.
9. Place end (with longest splines) of output coupling #8 through end bearing bushing #13 and mesh
coupling spline with spline inside of drum. Slide clutch spacer #30 over end and against shoulder
of shifter shaft #12. Place shifter shaft through washer #27 and into shaft coupling #6, meshing
splines of shifter shaft with splines in shaft coupling.
CAPSCREW
INNER-MOST
CAPSCREWS
OUTER-MOST
OUTER-MOST
CAPSCREW
41
10
1
41
9
17 24
29
29
24
17
29
29
24
17
LONGEST SPLINES
14
10
12
30
6
8
27