Ramsey Winch RPH-50000 (Mtg. Frame) - Manual (Page 3)

1
* These specifications are based on recommended wire rope of .875 inch
(Kgs.)...............................................................................22,670
Gear Reduction................................................................................51.35:1
Weight (without cable)....................................................798 lb. (362 Kgs.)
Rated Line Pull (lbs.).........................................................................50,000
** Last layer does not conform to SAE J706
dia. extra improved plow steel or equivalent
per layer
(at 25 GPM)
*Cable capacity
*Line speed
*Rated line pull
65
28
8.6
19
23
7.0
30
9
110
10.1
33
33
18,550
40,900 50,000
22,670 15,690
34,600
160 220
38
11.7
48
43
13.2
66
11,970
26,400
13,600
30,000 Lbs.
Kg.
Ft.
M.
FPM
MPM
RAMSEY HYDRAULIC PLANETARY WINCH MODEL RPH 50,000
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and safety
procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until you have carefully
read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch we make.
If the need should arise, warranty procedure is outlined on the back of your self-addressed postage paid warranty card.
Please read and fill out the enclosed warranty card and send it to Ramsey Winch Company. If you have any problems
with our winch, please follow instructions for prompt service on all warranty claims. Refer to back page for limited
warranty.
SPECIFICATIONS*
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.
WARNINGS:
VERIFY PROPER COUNTERBALANCE VALVE CARTRIDE AND PLUG POSITION FOR SPECIFIC INSTALLATION.
CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD. CABLE
ANCHOR IS NOT DESIGNED TO HOLD LOAD.