Ramsey Winch CHEVY GRILL GUARD KIT 295369 (PAT 12/15 WINCH) - Manual (Page 6)

17. Refer to Winch Owner’s Manual for instructions on
electrical connections. Be sure battery cables are
not drawn taut across any surfaces which could
possibly damage them.
Hint: Lift vehicle hood and remove plastic
shroud to get easy access to area between
grille and radiator to install cables.
18. Push battery cable into loom (Item #20) and slide
loom up cables as close as possible to mounting
frame assembly. Secure using cable ties (item #18)
at each end of loom. To improve appearance, wrap
ends of loom with electrical tape.
19. Plug remote switch into receptacle on top of sole-
noid. Run winch forward and reverse to check con-
nections. Snap appropriate “IN” and “OUT” disk into
proper thumb cavity, after determining winch operat-
ing direction. Do not leave switch plugged in when
winch is not in use.
20. Place end of wire rope through fairlead and attach
clevis hook. Use clevis pin and cotter pin (furnished
with winch).
21. Tighten all bolts to proper torque values (see Torque
Value chart).
6
Bolt Torque, Torque,
Size ft-lbs. Nm
1/4-20 5 ft-lbs 7 Nm
3/8-16 34 ft-lbs 46 Nm
1/2-13 87 ft-lbs 118 Nm
Torque Value Chart