Ramsey Winch CHEVY WRAPAROUND KIT 295922 - Manual (Page 5)

4
Figure 14 Figure 13
Repeat Steps 1-4 for right side of truck.
Make sure the tabs on the upper support brackets are in the
correct position (Figure 11).
Step 5
Slide lower L.H. mounting bracket #10 between tow hook and
frame mounting bracket #7 (Figure 13). Position lower
mounting shim #33 between the two brackets and secure using
(2) 1/2-13NC X 1-1/4” capscrews #19 and (2) 1/2” nuts #22
(Figure 14).
DO NOT TIGHTEN HARDWARE COMPLETELY.
Step 6
Note: You will need assistance for this step.
Have someone hold the center unit while you insert the winch mounting channel #2 between side
plates of center unit #5. Channel shims #29 are inserted between the end of the channel and the
side plate of the center unit on both sides. Secure each side of channel using (2) 3/8-16NC x 1-1/4
capscrews #18 with nuts #21 (Figure 15). Note: Do not tighten hardware at this location, as you will
need to remove these nuts to install the wraparound in a later step.
Step 7
Mount center unit on vehicle and secure each side at the lower support bracket using (3) 1/2” X 1-1/4”
capscrews #19 with (3) 1/2” nuts #22 (Figure 16). Attach each side of center unit to upper support
bracket using (1) 3/8-16NC x 1-1/4 capscrew #18 with nut #21 (Figure 17). Do not tighten hardware.
Figure 15
Figure 16 Figure 17