Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295946 & 295947 - Manual (Page 5)

When properly installed, upper support bracket will pro-
trude from vehicle between the vehicle grille and the top
of the front bumper. Small tab will mount to sideplate of
grille guard.
Note: The outer edges of the upper brackets should
be 32 1/4” or slightly less apart and the inner edges
of the lower brackets should be 32 7/8” or slightly
more apart in order to attach the center unit to them.
Because the mounting hardware for these brackets
need to be tightened prior to attaching the center unit
to them, make sure the spacing is correct before you
tighten the mounting hardware. Once the bumper is
re-installed, it will not be possible to adjust the
mounting hardware for these brackets.
10. Install lower mounting brackets (Item #3 & #4) to
frame rails at tow hook holes. Use (3) 12mm x 40 mm
capscrews (item #11), (3) 1/2” lockwashers (item
#19), and (3) 12mm hex nuts (item #15) per side.
Tighten hardware for upper and lower mounting brack-
ets before bumper is re-installed. Refer to Torque Value
Chart for proper torque.
11. Re-install bumper. Bumper should slip over lower
mounting brackets.
12. Re-install blocker bar.
5