Ramsey Winch RPH 10000XT User Manual
Page 15
13
Before installing motor, check brake adjustment (refer to page 7, ADJUSTING THE
BRAKE).
Place splined end of coupling (item #32), with spirol pin installed, inside of motor end
bearing housing (item #7) and slide over splines on end of input shaft. Place o-ring (item
#39) around motor pilot. Mount motor (item #36) to end bearing by aligning key on
motor shaft with keyway in coupling. Be sure that motor mounts flush to end bearing
and that o-ring is set securely in place between motor and end bearing. Secure motor to
end bearing using two capscrews and lockwashers (items #25 & #31). Tighten
capscrews to 49 Ft. Lbs. (66 Nm). Thread plug (item #41) into bottom of brake housing.
Permatex can be added to threads of plug to help in sealing. Pour a mixture of 8 oz. of
Mobilfluid 424, Phillips HG Fluid, Texaco TDH, Shell Oil Co. Donax TD high
performance tractor transmission fluid, or equivalent and 1/4 oz. of an additive
(available from the factory), into oil level hole. Oil level should be kept at oil level hole
(plus or minus 1/8"). Thread plug (item #41) into oil level hole. Insert reducer (item #40)
into hole in top of brake housing and breather plug (item #35) into reducer. Tighten
plugs and reducer securely.