Ramsey Winch H-800 W/AIR SHIFTER (TALBERT) - Manual (Page 12)

12
(7)
Remove gear housing cover (item #16) from gear housing (item
#21) by unscrewing eight capscrews (item #45). Thread two of
the capscrews into the two tapped holes of cover and tighten.
This will pull the cover loose from gear housing.
Remove cover gasket (item #78) and pull shaft (item #28), with
gear (item #18) and spacer (item #84) attached, from gear hous-
ing.
(8)
Check for signs of wear on gear teeth. If necessary, replace gear.
Check lube fittings (item #82) for damage and replace if necessary.
Remove lube fittings and reducers (item #86) from ends of shaft, if
following Step 9, and reinstall after Step 9.
(9)
If shaft and/or gear is damaged, replace as follows:
a. Tap keys (item #25) into short keyways of drum shaft (item
#27).
b. Press shaft (item #27) and keys through gear hub (item
#17) until end of keys on long end of shaft are flush with
hub.
(10)
Check gear housing bushing (item #10) and quad ring (item #84)
for signs of wear. Replace if necessary by pressing old bushing
from gear housing (item #21). Press new bushing into place and
insert new quad ring into groove inside of bushing.