Ramsey Winch H-930r DOW-LOK w/Air Shifter for Grant Wrecker - Manual (Page 12)

9. Check gear housing bushing (item #6) and o-ring (item #76) for
signs of wear. Replace if necessary by pressing old bushing from
gear housing. Press new bushing into place and insert new o-ring
into groove inside of bushing.
10. Check drum bushings (items #35 and #36) for
signs of wear. Replace if necessary by pressing
old bushings from drum (item #1). Press bush-
ing (item #35) into bore in drum until its flange
is seated against bottom of counterbore. Press
bushing (item #36) into opposite bore on drum
until end of bushing extends .5” from end of
drum.
11. Check end bearing bushing (item #36) for signs of
wear. If necessary, remove old bushing and press
new bushing into place.
12. Check cover bushing (item #6) and o-ring (item
#76) for signs of wear. Replace if necessary by
pressing old bushing from gear housing. Press new
bushing into place and insert new o-ring into groove
inside of bushing.
18
6
76
10