Ramsey Winch HDG-350 (JERR-DAN) (NOT CURRENT) - Manual (Page 13)

6. Check for signs of wear on gear teeth. If
replacement of gear is necessary, replace as
follows:
a) Press gear (item #11) from shaft (item
#18).
b) Examine shaft keys and keyways. If distor-
tion of keys and/or keyways is evident,
shaft and keys should be replaced.
c) Use a soft hammer to gently tap keys
(item #44) into keyways. Press gear (item
#11) over shaft and keys. Gear must be
centered over keys.
7. Remove seal (item #55) from back of (item
#13) gear housing. Press bushing (item
#23) from gear housing. Press new bushing
and seal back into place.
8. Check drum bushings (item #22) for signs
of wear. Replace if necessary by pressing
old bushings from drum. Press new ones
into place.
9. Examine shifter assembly (item #2) for
damage to yoke. Yoke should be firmly
attached to shaft, yet, able to swivel
freely around shaft. Replace if neces-
sary.
Install new shifter assembly (item #2)
by placing end of shaft, opposite yoke,
through spring (item #60) and into
housing (item #14).
13