Ramsey Winch RPH-25000 (JERR-DAN) - Manual (Page 13)

11. Place (2) gear carrier assemblies into ring gear meshing carrier gears with ring gear. Make
sure that ring gear and carrier assemblies are securely against end bearing (item #14).
Apply RTV sealing compound to cover mounting surface of ring gear and attach cover to
ring gear. Use (8) capscrews (item #25) to secure gearbox cover to gear housing end
bearing. Torque capscrews to 18 ft-lbs. each, in criss-cross pattern.
12. Pull rod from air cylinder as far as possible. Slide washer (item #43) over setscrew (item
#36) and against nut attached to air cylinder rod. Place setscrew into hole of shifter shaft
(item #17). Attach new air cylinder (item #52) and gasket (item #56) with sealer, to
cover using (4) capscrews (item #38). Apply Loc-tite PST thread sealer to threads of
capscrews. Torque capscrews to 5 ft-lbs. each, in criss-cross pattern.
11