Ramsey Winch RPH-50000 LARGE FLANGE W/AIR TENSIONER (OBSOLETE) - Manual (Page 8)

5
TROUBLE SHOOTING GUIDE
CONDITIONS POSSIBLE CAUSE CORRECTION
1. Seals damaged or worn. 1. Replace seal.
2. Too much oil. 2. Drain excess oil. Refer to
OPERATION.
OIL LEAKS FROM
WINCH
3. Damaged gaskets. 3. Replace gaskets.
1. Low flow rate. 1. Check flow rate. Refer to
HYDRAULIC SYSTEMS
performance chart page 2.
WINCH RUNS TOO
SLOW
2. Hydraulic motor worn out. 2. Replace motor.
CABLE DRUM WILL
NOT FREESPOOL
1. Clutch not disengaged. 1. Check air pressure to clutch
cylinder 100 PSI min. required
Refer to page 16 for port location.
BRAKE WLL NOT
RELEASE 1. Brake line disconnected or blocked. 1. Check brake function. Refer to
page 13.
LOAD LOWERS TOO
FAST
1. Hydraulic lines to counter-balance
valve incorrectly installed and/or
cartridge plug position incorrect for
drum rotation direction to reel cable in.
1. Refer to View A-A pg. 16 for correct
installation.