Val-Matic Rubber-Seated Ball Valve - Manual (Page 12)

12
4. Apply a thin film of FDA silicone grease such as
Dow Corning #7 to the exposed rubber surface
and close the valve so that the ball is parallel with
the valve flange face with in +/- 1/8 in.
5. Tighten the seat bolts in a cross-over pattern to
the torque given in Table 4 using a torque wrench.
6. Cycle valve open and closed and verify that ball
closes within +/- ¼ in of center. Conduct a
pressure test. If necessary, tighten screws ½ turn
to stop any leakage.
PARTS AND SERVICE
Parts and service are available from your local
representative or the factory. Make note of the valve
Size, Series No, and Serial No. located on the valve
nameplate and contact:
Val-Matic Valve and Mfg. Corp.
905 Riverside Drive
Elmhurst, IL 60126
PH: 630 / 941-7600
FAX: 630 / 941-8042
A sales representative will quote prices for parts or
arrange for service as needed.
VALVE AND MANUFACTURING CORP.
905 Riverside Dr. ● Elmhurst, IL 60126
Phone (630) 941-7600 ● Fax (630) 941-8042
www.valmatic.com
LIMITED WARRANTY
All products are warranted to be free of defects in material and workmanship for a period of one year from the date of shipment,
subject to the limitations below.
If the purchaser believes a product is defective, the purchaser shall: (a) Notify the manufacturer, state the alleged defect and
request permission to return the product; (b) if permission is given, return the product with transportation prepaid. If the product
is accepted for return and found to be defective, the manufacturer will, at his discretion, either repair or replace the product,
f.o.b. factory, within 60 days of receipt, or refund the purchase price. Other than to repair, replace or refund as described above,
purchaser agrees that manufacturer shall not be liable for any loss, costs, expenses or damages of any kind arising out of the
product, its use, installation or replacement, labeling, instructions, information or technical data of any kind, description of
product use, sample or model, warnings or lack of any of the foregoing. NO OTHER WARRANTIES, WRITTEN OR ORAL,
EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND
MERCHANTABILITY, ARE MADE OR AUTHORIZED. NO AFFIRMATION OF FACT, PROMISE, DESCRIPTION OF
PRODUCT OF USE OR SAMPLE OR MODEL SHALL CREATE ANY WARRANTY FROM MANUFACTURER, UNLESS
SIGNED BY THE PRESIDENT OF THE MANUFACTURER. These products are not manufactured, sold or intended for
personal, family or household purposes.