ATO CMM 900-3W - Manual (Page 6)

Page 6 of 6
2. SPECIFICATIONS
Air Speed Up to 9600 bps
DTE Rate 300, 1200, 2400, 9600, 19200, 57600 bps (DIP
switch selectable)
Data Compression & Error Detection
MNP2-5, V42, V42bis, MNP 10
Transmit Power 3 W
Power Supply 5 volts DC @ 1500 ma
Interface RS 232 Asynchronous
Signals supported TXD, RXD, CD, DSR, RTS, CTS, RI, DTR
Operating Temperature Range -10
°
C to +70
°
C
Custom Configurations Yes
3.0 MODEM SETUP AND REGISTRATION
3.1 What you need to provide:
•
5 Volts, 1500 ma regulated DC Power Supply
•
Host PC with a terminal program, such as Hyper terminal, ProComm etc.
•
Mobile Identification Number (MIN) provided by your Cellular service provider.
MIN is your cellular phone number.
•
System ID (SID) information (from your cellular service provider) SID uniquely
identifies your cellular service provider.
3.2 Registering the Cellular Modem Unit:
To register your cellular modem unit, do the following:
•
Contact your cellular service provider
•
Provide the cellular operator with the ESN (Electronic Serial Number) number
located on the label at the top of your unit.
•
Inform the cellular operator that the unit is an AMPS ONLY ANALOG unit with
a power rating of Class 1 (power 3 W).
•
The cellular operator will register your unit and provide you the following
information:
o MIN (Mobile Number) Number
o System preference: A or B
o SID (System ID)