Progressive International Electronics EZ Wire DBox - Manual (Page 23)

PI DBox Installation Guide
Version 5.0 January 2012
Page 19
3. Referring to Diagram: Key Components of PI DBox — Kraus/Bennett Style for Kraus
Application, configure jumpers. At position JP5, set the jumper to Kraus. Locate jumpers
JP4, JP3, and JP2. Jumper the appropriate position for the type of interface to be used:
RS232 interface — jumper only position JP4
Ethernet (XPort) interface — jumper only position JP3
PIE product (PiPort) interface — jumper only position JP2
4. Proceed with programming of the system.
Note: For MTI (D&H) computer heads, the TTC and TTP signals must be jumpered to the second
address (i.e., 1 to 2, 3 to 4, 5 to 6, . . . . 15 to 16). Refer to the board orientation for the dispenser
position.
The MTI (D&H) heads must be upgraded to the latest hardware version for the communication to
operate properly. Please contact MTI (Measurement Technology, Inc.) for upgrades.