Maple Systems MAP450D - Manual (Page 15)

Network Address Setting
This parameter determines the network address used by the host controller to
communicate with this OIT when in Network mode. Options are 1 to 255.
Factory Default: Not Applicable
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, enter the desired network address in the
Network Addr. text box.
To modify this parameter in Configuration mode:
1. At Network Address:, use the OIT’s Period (.) key to select the desired network
address. Refer to the Configuration Mode section in this chapter for more
information.
To modify this parameter from the host controller:
1. Use the Set Operating Mode control command. Refer to Appendix A: Control
Commands for more information.
Tab Width Setting
This parameter determines how many spaces the OIT moves the cursor when the HT
control code (hexadecimal 09) is received from the host controller. Options are 1 Space, 4
Spaces, and 8 Spaces.
Factory Default: 1 Space
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the desired tab width in the Tab
Width list box.
To modify this parameter in Configuration mode:
1. At Tab Width:, use the OIT’s Period (.) key to select the desired tab width. Refer to
the Configuration Mode section in this chapter for more information.
To modify this parameter from the host controller:
1. Use the Set Tab Character Width control command. Refer to Appendix A: Control
Commands for more information.
Chapter 1: OIT Configuration 14
1010-0101, Rev. 00