Proface LT3200 - 3.8 All-in-One HMI" - Manual (Page 2)

-2-
WARNING
• Disconnect all the power before servicing equipment.Otherwise an electric shock may occur.
• Do not disassemble or remodel the ABL-DRM03024, since it may lead to an electric shock or fire.
• Do not use the ABL-DRM03024 in an environment that contains flammable gases, since an explo-
sion may occur.
• Do not use the ABL-DRM03024 in an environment that is not specified in this guide. Otherwise, an
electric shock, fire, malfunction or other failure may occur.
• Because of the possibility of an electric shock or malfunction, do not touch any power terminals
while this product is operating.
• Be sure to install the ABL-DRM03024 according to directions in this guide. Improper installation
may cause this product to malfunction or fail.
• Be sure to wire this product according to the directions in this guide. Improper wiring may cause a
malfunction, failure or electric shock.
• Do not allow foreign substances, including chips, wire pieces, water, or liquids to enter inside this
product’s case. Otherwise, a malfunction, failure, electric shock or fire may occur.
• Be sure this product is operated only by personnel trained in control system programming and
design.
• Do not touch this product with wet hands or wipe it with a wet cloth. Doing so may cause a fire or an
electric shock.
• Be sure to install a fuse, breaker etc. in each of the power, input and output circuits. Failure to do so
can lead to a fire if an overload occurs.
• When disposing off this product, be sure to do so according to your country’s standards for indus-
trial waste disposal.
CAUTION
„ „ „ „ „ To Prevent ABL-DRM03024 Damage
• Do not store or operate the ABL-DRM03024 in either direct sunlight or excessively dusty or
dirty environments.
• Because this product is a precision instrument, do not store or use it in locations where exces-
sive shocks or vibration may occur.
• Do not cover this product’s ventilation holes, or operate it in an environment that may cause it to
overheat.
• Do not operate this product in locations where sudden temperature changes can cause con-
densation to form inside this product.
• Do not use paint thinner or organic solvents to clean this product.
„ „ „ „ „ Paralleling
• The parallel connection of the ABL-DRM03024 makes it possible to output the double current
only when two pieces of ABL-DRM03024 are paralleled.
• In order to improve heat dissipation, be sure not to set two ABL-DRM03024 in contact with
each other. In any condition, please make space at least 50mm(1.97 inch) on top and bottom
of this product and 15mm(0.59 inch) for both sides of this product.
• Set the same output voltage of each ABL-DRM03024 separately by adjusting [V Out] before
plugging them together.