Proface FP3900 - 19 Flat Panel" - Manual (Page 2)

-2-
© Copyright 2004 Digital Electronics Corporation
1 Installation
During installation be sure not to pinch your hand or fingers between
the PS-A/FP unit and any of the 15-inch Unit Covers.
CAUTION
1) Remove the PS-A/FP unit's Moisture Resistant Gasket and two (2) rear face
screws (See *1 below) and one (1) rear face screw (See *2 below). Be sure to
save these screws.
2) Attach the Angle Plate to the right-side cover and secure them to the PS-A/FP
unit's *2 part using an attachment screw removed in Step 1. (Required torque:
0.5 to 0.6 N•m.)
3) Then, secure the right-side cover to the PS-A/FP unit's *1 parts using two(2)
attachment screws removed in Step 1. (Required torque: 0.5 to 0.6 N•m.)
Next, secure the left-side cover to the PS-A/FP unit using two(2) attachment
screws. (Required torque: 0.5 to 0.6 N•m.)
Digital Electronics Corporation
8-2-52 Nanko Higashi, Suminoe-ku,
Osaka 559-0031, Japan
URL: http://www.pro-face.com/
*1
Top Cover
Attachment
Screws
PS-3711A
Remove the portion of the cover using a
nipper as shown the right figure depend-
ing on which interface of the PS-A/FP
you use.
*2
Left-side
cover
Angle Plate
Note
Be aware that the Digital Electronics
Corporation shall not be held liable for any real
or estimated damages or losses, or third party
claims resulting from the use of this product.
4) Finally, use the two (2) attachment screws
to secure the top cover to the PS-A/FP.
(Required torque: 0.5 to 0.6 N•m.)
Right-side
cover
Right-side
Cover
Remove here when using
LAN or PS/2 Keyboard
I/F for PS-3711A.
Remove
here when
using
PCMCIA I/F
for PS-A.
Remove here when using
CD-ROM Drive Unit PSS-
CD01 for PS-3701A.
For PS-3701A & FP
For PS-3711A
Left-side Cover