Avenview FO-DVI-DL-330X - Manual (Page 9)

www.avenview.com 9
Problem Possible Solution
Power ON
Power LED does not
work

Please check out voltage of adapter. (DC +5V)

Ensure that power adapter correctly plugged
Cannot read selected
EDID

Select switch the emulation mode
- Retry self EDID read
- Check the monitor to read EDID

Select switch the real mode.
- Please check and connected the UTP cable. (Only the direct
type)
- Please check if the DVI cable is connected.
Resolution Issue

Select single mode switch
- Max resolution 1920x1200@60Hz
- Some monitor will not support this mode.

Select dual mode switch
- Max resolution 2560x1600@60Hz
- Please check and connect DVI cable type (Should use DVI-Dual
cable)

Noise or no display
- Please check the DVI and optical fiber cable is connected.
*** The max resolution is different on to connected monitor
Self EDID Setting :
1) DDC function switch set to Emulation.
2) DVI cable connection between TX and display.
3) Supply power to TX (DC +5[V]).
4) LED blink -> LED ON