Pfister 049-CNFC - Manual (Page 4)

Thank you for purchasing this Price Pfister product. All Price
Pfister products are carefully engineered, and factory tested
to provide long trouble-free use under normal conditions.
This product is easy to install using basic tools and our easy
to follow illustrated instructions. If you have any questions
regarding this product, see info on previous page.
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before
proceeding. Price Pfister recommends calling a professional
if you are uncertain about installing this product!
This product should be installed in accordance with all local
and state plumbing and building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply
valves. These are usually found under the sink or near
the water meter. If you are replacing an existing Faucet,
remove the old Faucet from the sink and clean the sink
surface thoroughly.
3 ASSEMBLY INSTRUCTIONS
If operating pressures exceed 5 BAR (75 PSI), the use of
a pressure reducer is recommended. Before proceeding
with the assembling, we advise to clean the hot and cold
water tubes, in order to avoid build-up of dirt that could
compromise the functioning of the Faucet.
4 VALVE INSTALLATION (Fig.A)
Place Rubber Washer (1), Metal Washer (2) and Mounting
Nut (3) onto Valve Body (4). From underneath the sink,
insert Valve Body (4) through Mounting Holes. From above,
place Seal Base (6) on top of Valve Body (4). Attach Handle
Hubs (7) onto Valve Stems (8) and tighten Set Screws (9)
with a Hex Wrench. Make sure that Valves are in the
“Closed” position. Attach Decorative Button (10). Tighten
mounting nut (3), so that the bottom of Handle Hubs (7) sit
flush with sink surface. To remove handle, reverse steps.
5 SPOUT INSTALLATION (Fig.B)
Place Seal Base (1) against the bottom of Spout Body (2).
With Spout Body (2) facing forward, carefully insert Shanks
(3) through the center hole of sink (4). From underneath
sink, secure Spout Body (2) by placing Rubber Washer (5)
and Metal Washer (6) and threading Mounting Nuts (7) onto
Shanks (3). Caution: Do not over tighten!
Supply Suggested Maximum Minimum
Hot Water
Temperature
65 Cº (150ºF) 80 Cº (175ºF) 15 Cº (60ºF)
Operating
Pressure
3 BAR (44PSI) 5 BAR (73PSI) 0.5 BAR (7PSI)
ENGLISH A
8 6
4
1
3
2
7
9
10
B
1
3
7
4
5
6
2
4