Pfister E27-BNFC - Manual (Page 7)

10
9
outside edge of the deck plate (B). To continue with
the installation, go to step 2A.
1B INSTALLING SINGLE POST RING
Pass single post ring (A) over copper inlet / outlet
tubes (B), and press onto faucet body (C). Note:
The tabs on the faucet body (C) must be aligned
to the grooves inside the single post ring (B). To
ensure this is the case, rotate the single post ring
(B). When the tabs are aligned, the ring will cease
to rotate.
2A INSTALLING THE FAUCET USING THE
OPTIONAL DECK PLATE
Ensure that the mounting gasket (A) is pressed
frimly in to the faucet body (B). Feed the pull-out
hose (C) up through the faucet body (B), until the
pull-out hose fitting is flush with the bottom of the
mounting shank (D) (see illustration). Insert the
faucet supply tubes (E) and mounting shank (D)
through the hole in the deck plate (F). Note: The
tabs on the faucet body (B) must be aligned to the
grooves inside the deck plate (F). To ensure this is
the case, rotate the faucet body (B) back and forth.
When the tabs are aligned, the faucet will cease to
rotate.
From underneath sink, feed the lockwasher (G) and
brass mounting nut (H) over the supply tubes (E).
Thread the brass mounting nut on to the mounting
shank (D). Wrench tighten brass mounting nut (H),
until faucet is firmly secured to sink.
2B INSTALLING THE FAUCET USING THE SINGLE
POST RING
Ensure that the mounting gasket (A) is pressed
frimly in to the faucet body (B). Feed the pull-out
hose (C) up through the faucet body (B), until the
pull-out hose fitting is flush with the bottom of the
mounting shank (D) (see illustration). Insert the
faucet supply tubes (E) and mounting shank (D)
through the hole in the sink.
From underneath sink, feed the lockwasher (F) and
Pour toute question ou problème
concernant les produits Price
Pfister, s’adresser au distributeur ou
point de contact local Price Pfister.
7
FRANÇAIS
10B
10A
10C
10D
10E