Audiovox FPE1705 - Manual (Page 33)

Operations in VGA /YPbPr mode
Select VGA/YPbPr mode
PC signal format
Auto adjusting
Connect VGA input and be sure that there is VGA input signal. The
signal format should be set to: 1280 x 768 @ 60Hz.
Note:
The resolution of the LCD panel is ; any higher
Resolution output from your PC Video card might distort the
image
1280 x 768
.
1
Press the SOURCE button on the unit
or button on the remote control.
The screen displays the menu shown
as right.
2
Press CH5/6 to highlight the VGA or
YPbPr/YCbCr item. Press VOL+/- or
wait about 4 seconds and the signal
source is selected.
SOURCE
TV
AV
SVIDEO
YPbPr/YCbCr
VGA
When VGA signal format is
changed or when you switch to
VGA mode from another source,
the unit adjusts frequency and
phase automatically to obtain the
best display. During the process of
auto correction, the screen
displays Analog RGB Acquiring
Signal, and all buttons on the set
and on the remote control do not
work until this process is finished.
When the set displays some nonstandard VGA signals and can
not adjust the picture to the best status by itself, you can adjust it
again by pressing the AUTO. ADJ button on the remote
control.
NOTE: Please note your final phase and frequency settings as
you might need to re-adjust your screen.
33
Analog RGB
Acquiring Signal
VGA
S.M