Wright Serial # 69788 and Higher - Manual (Page 19)

19
4.3 Control Panel & Steering Control Levers
The Stander Intensity speed and direction are controlled by using the control handles. Moving the control
handles equal distance forward or backward the machine moves in a straight line. By releasing the control
handles during operation, the controls will return to the neutral position and the machine will stop.
1
– Left Forward Motion Control Handle
2 – Left Reverse Motion Control Handle
3 – Right Reverse Motion Control Handle
4
– Right Forward Motion Control Handle
5
– Stationary Handle Bar
6 – Choke
7 – Digital Hour Meter
8
– Throttle
9 – PTO Switch
10 – Ignition Switch/Key
4.4 Digital Hour Meter
The Stander Intensity is equipped with a digital hour meter. Refer to operating/reset instructions below.
The programming specified is:

Default display: Hours

Press once (TMR1): Timer 1, press for 3 sec to reset

Press twice (TMR2): Timer 2, press for 3 sec to reset

Press three times (svc ENG): Will display time remaining until next service
point, hold down to reset. The first interval is 8hr, thereafter
100hr.
Beginning 5hr before service point the meter will flash “svc ENG, in
[remaining hours]” every 5 sec.

Shut off engine: Will display how many times the engine has started.
4.5 Fuel System / Shut-Off Valve
The fuel shut-off valve and fuel gauge is located on top of the fuel tank. The
valve should be in the “OFF” position at all times when the mower is not in
use. Do Not fill the tank completely. Max fill level is at the base of the fill
neck. This will allow for the gas to expand
1
2 3
4
5
6
7
8
9
10
Off
On
Max fill level