Lfcc compliance – Yokogawa YFGW510 User Manual
Page 7
7
<Read Me First>
IM 01W02E01-11EN
Destination countries are as follows:
AT
BE
BG
CY
CZ
DK
EE
FI
FR
DE
GR
HU
IE
IT
LV
LT
LU
MT
NL
PL
PT
RO
SK
SI
ES
SE
GB
IS
LI
NO
CH
IEEE 802.11a Restrictions:
YFGW510 is for indoor use only when using channels 36, 40, 44, 48, 52, 56, 60, or 64 (5150–
5350 MHz).
l
FCC compliance
YFGW510 contains transmitter module
• FCC ID: SGJ-WFC006 (All Model)
• FCC ID: SGJ-WFC008 (Wireless LAN Single Model)
• FCC ID: SGJ-WFC009 (Wireless LAN Redundant Model)
Co-located:
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
RF Exposure Compliance:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ-
ment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65.
This equipment has very low levels of RF energy that it deemed to comply without maximum
permissive exposure evaluation (MPE). But it is desirable that it should be installed and oper-
ated keeping the radiator at least 20cm or more away from person’s body (excluding extremities:
hands, wrists, feet and ankles).