Yokogawa Removable Chassis DX1000N - Manual (Page 32)

3-11
IM 04L41B01-03E
Operations
1
2
3
Index
3.5 Using Batch Single Mode
Follow the procedure below when the batch single mode screen is displayed. In batch
single mode, only the selected batch group’s data is displayed.
Procedure
• Opening the Display
1. Press DISP/ENTER to open the display selection menu.
2. Use the arrow keys to select a menu item. When there is a submenu, select a
submenu item, and press DISP/ENTER.
The selected display appears.
TREND, DIGITAL, and BAR
For operating instructions, see section 4.2 in the User’s Manual.
CUSTOM DISPLAY
For operating instructions, see IM04L41B01-04E.
OVERVIEW
Displays the status of all channels registered to the batch group.
For operating instructions, see section 4.4 in the User’s Manual.
ALARM SUMMARY, MESSAGE SUMMARY, and MEMORY SUMMARY
For operating instructions, see sections 4.6, 4.7, and 4.8 in the User’s Manual.
4-PANEL
For operating instructions, see section 4.10 in the DX2000 User’s Manual.
• Loading Display and Event Data
You can use the following procedure to load display or event data and display the
corresponding historical trend.
Press
MENU (to switch to setting mode), and select the File tab > Load display
data or Load event data > press the CF or USB soft key > select the file and press
DISP/ENTER
Take note of the following points regarding loading of data.
• You can load any batch group’s data.
• Whether you load the data for the currently displayed batch group or another batch
group, the currently displayed batch group does not change.