Yokogawa JUXTA VJH7 - Manual

User’s
Manual Model VJH7
Isolator (Multi-function)
(Isolated Single-output and
Isolated Dual-output Types)
IM 77J01H07-01E
IM 77J01H07-01E
1st Edition Nov. 1999
2nd Edition June 2004
1. CAUTIONARY NOTES FOR SAFE
USE OF THE PRODUCT
For the correct use of this product, read through this manual before
use. The following safety symbol is indicated on the product to en-
sure safe use.
CAUTION
If this symbol is indicated on the product, the operator
should refer to the explanation given in the instruction
manual in order to avoid personnel injury or death to either
themselves or other personnel, and/or damage to the instru-
ment. The manual describes the special care the operator
should exercise to avoid shock or other dangers that may re-
sult in injury or loss of life.
The following symbol marks are used only in this manual.
IMPORTANT
Indicates that operating the hardware or software in a par-
ticular manner may damage it or result in a system failure.
NOTE
Draws attention to information that is essential for under-
standing the operations and/or features of the product.
2. CHECKING PRODUCT SPECIFI-
CATIONS AND THE CONTENTS
OF PACKING
(1) Model Number and Specification Check
Check that the model number and specifications shown on the
nameplate attached on the side of the product are as ordered.
(2) Contents of the Packing
Check that the packing contains the following items:
● VJH7 main unit, 1
● Instruction Manual (IM 77J1H07-01E), 1
Accessories:
● Tag number label, 1
● Renge label, 1
● Shunt registor (for specification of current input), 1
3. GENERAL
This plug-in isolator, which belongs to the JUXTA series of signal
conditioners, receives DC current or voltage signals and converts
them to pairs of isolated DC voltage or current signals.
• Output-2 signal is selectable from a DC voltage signal, DC
current signal, communication function (RS-485), and alarm
output (two relay contacts).
4. MOUNTING METHODS
4.1 Wall Mounting
Loosen the main unit-fixing screw of the isolator to disconnect the
main unit from the socket. Next, anchor the socket onto the wall
with screws. Then, plug the main unit into the socket and secure
the main unit with the main unit-fixing screw.
Main
unit-fixing
screw
Socket
Main unit
Threaded hole for
fixing the main unit
Mounting
screws
<Mounting Dimensions>
Unit: mm
29.5 or more
22
±
0.2
59
± 0.3
2-M4 or 2-ø4.5 or more
Fig. 4.1
4.2 DIN Rail Mounting
Locate the isolator so that the DIN rail fits into the upper part of
the DIN-rail groove at the rear of the socket, and fasten the socket
using the slide lock at the lower part of the socket.
Slide lock
DIN rail
DIN rail
VIEW A (Rear of socket)
VIEW A
Fig. 4.2
Keep this manual in a safe place.
Network Solutions Business Divisiion
2-9-32, Naka-cho Musashino-shi, Tokyo 180-8750 Japan
Phone: +81-422-52-7179
Facsimile: +81-422-52-6793