Thermolec Split|Steam - Manual (Page 20)

CONTRACT
OR
Page 18
14.3 Attached the mounting fl anges to the fan module with the screws provided but do not tighten the screws
so that the fl anges are able to slide along the slots. Slide the fan module into the wall until the front edge is
fl ush with the wall, fi gure 14c. Tighten the screws holding the tabs so that the front remains fl ush with the wall.
Level the unit and screw the fl anges to the wall.
14.4 Push the faceplate on the front until is snaps into place. Check to be sure that the faceplate completely
covers the opening in the wall.
Once the steam generator is installed, connect the steam hose between the difuser in the fan module and the
tank in the steam generator with the clamps provided and wire the fan module according to the wiring diagram
near the end of this booklet.
flush
Fig. 14c