Pro-Cut Warthog - Manual (Page 29)

WWW.PROCUTUSA.COM PG / Ø29
MACHINE CARE
MAINTENANCE
Check cutting tip edges. If there are chips or dings, turn or replace the tip. Be sure they are right-side up so that
the groove and dots are visible. Each tip has three cutting points. When worn out, replace them using a 2mm al-
len wrench as the one provided with the tool kit. Although the tips must be securely tightened, do not over-tighten
them either. When changing tool tips, clean the threads and put a spot of Vaseline ® (or thick grease) in the bottom
of the screw hole before tightening the tool bit screw. The Vaseline / grease will stop chips from accumulating in
the hole and rusting in place. If chips do rust in place, they can often be dislodged by poking a needle through the
hole.
Clean the slide plate (50-496) and tool holder plate (50-293), taking special care that there are not chips or dirt
wedged in the dovetails or under the tool arms. Clean loose cast-iron chips from the magnetic tip on the adjustment
flange to maintain a clear signal to the computer. Check the electrical connections and cord for cuts in the insula-
tion or for wear.
The Pro-Cut lathe is simple and rugged. With just a few maintenance tips you can ensure a long and profitable life for your machine.
HELPFUL HINTS FOR CUTTING ROTORS USING A PRO-CUT LATHE
– If the vehicle has a floating locking rear axle, remove the axle prior to attaching lathe.
– If AWD vehicle and all 4 wheels turn, remove all 4 wheels and calipers.
– After cutting rotors, sand each side for 1 minute with 150 grit sandpaper, then wash with soap and water until
all residue is removed.