MAHLE RTI ATX-2PS - Manual (Page 9)

Page 8
FLUSH
1. Vehicle engine is running and the ATX-2 is connected as previously described, READY light
is illuminated.
2. Slowly add Flush Solution as recommenced by the supplier into the vehicle through the
transmission system dip stick port.
3. The ATX-2 will now circulate the solution through the transmission system until a procedure
is selected. The Flush Solution will be removed from the system during the exchange
procedure.
DRAIN PAN
Note: If transmission filter is to be replaced, perform the following procedure before
removing the transmission pan. If not, skip to the next procedure.
1. Vehicle engine is running and the ATX-2 is connected as previously described, READY light
is illuminated.
2. Press the DRAIN PAN button on the keypad.
3. Buzzer will sound once and DRAIN PAN light will stay illuminated. If an error occurs the
buzzer will sound three times and the ATX-2 will not proceed with the procedure, check all
connections.
4. Vehicle transmission pump will empty contents of transmission system into the ATX-2 used
fluid tank. Liquid level can be viewed through the Used Fluid Level Indicator on the left side of
the ATX-2.
5. When vehicle pan is emptied of transmission fluid the ATX-2 will automatically switch to the
circulate mode, the buzzer will sound continuously and the PROCESS COMPLETE light will
stay illuminated until the STOP button is pressed.
6. Turn the vehicle off IMMEDIATELY after ATX-2 buzzer sounds. The vehicle is now ready to
have the transmission pan removed.
7. After the pan is replaced, refill the pan using the +1/2 Quart button (refer to the +1/2 QUART
section). Check the transmission dip stick periodically while refilling to reach proper level.
- Caution -
Do not let the engine run for more than one minute after the
ATX-2 buzzer sounds. Letting the transmission run with an empty
pan for an extended amount of time can cause serious damage to
the transmission system.