MAHLE RTI MCX-2 (Rev F) - Manual (Page 8)

Page 7
Connecting at Engine
Pump
Water
Radiator
Overflow
Green Hose
Black Hose
Adapters
Step Hose
Radiator
Block
Engine
Connecting at Radiator
Radiator
Overflow
Black Hose
Green Hose
Core
Adapter
Block
Engine
Hose
Heater
Step
Adapters
Adapter
Hose
Pump
Water
Hose
Radiator
Core
Heater
EM PTY W AST E TA NK
FIL L R ADI ATO R & OVE RFL OW
EXC HAN GE CO O LA NT O R
LO WE R R ADIA TOR & O VER FLO W
& O VER FLO W LOW ER R ADIA TO R EM PTY W AST E TA NK
EXC HAN GE CO OLA NT & O VER FLO W FILL RA DIA TOR
SYS TEM PR ESS URE
SYS TEM VA CUU M
TES T OFF
OFF
OFF
EMP TY WA STE TA NK
FIL L R ADIA TO R & OVE RFL OW
EXC HA NGE CO OLA NT O R
LO WE R R ADIA TO R & O VER FLO W
& O VER FLO W
LOW ER RA DIA TOR EM PTY WA STE TAN K EXC HAN GE CO OLA NT & O VER FLO W
FILL RA DIA TOR
SYS TEM PR ESS UR E
SYS TEM VA CUU M
TES T OFF
OFF
OFF
CONNECTING TO THE COOLANT SYSTEM
The MCX-2S can be connected to the cooling system in either of the configurations
shown below. The choice is dependent on the ease of accessability to the hose
connections.
1. Disconnect the radiator hose from either the engine or the radiator.
2. Select an Adapter Hose with the same inner diameter as the radiator hose and
connect at the point the radiator hose was disconnected using a clamp.
3. Install Step Adapters in the Adapter Hose and the radiator hose using clamps.
Make sure the outside diameter of the Step Adapters is the same as the inner
diameter of the radiator hose.
4. Connect the Green and Black hoses from the MCX-2S to the two Step
Adapters as shown in the illustrations. See next page for special hookups.
5. Open the valves on the two Step Adapters.