Stuart Turner 3.2 bar PS - Manual (Page 18)

- 18 -
YOUR 2 YEAR GUARANTEE
Stuart Pumps are guaranteed by Stuart Turner Limited to be free from defects in
materials or workmanship for the applicable guarantee period from the date of purchase.
The applicable guarantee period is stated in the installation booklet supplied with the
pump. Within the guarantee period we will repair, free of charge, any defects in the pump
resulting from faults in material or workmanship, repairing, exchanging parts or exchanging
the whole unit as we may reasonably decide.
Not covered by this guarantee: Damage arising from incorrect installation, improper use,
unauthorised repair, normal wear and tear and defects which have a negligible effect on
the value or operation of the pump.
Reasonable evidence must be supplied that the pump has been purchased within the
applicable guarantee period prior to the date of claim (such as proof of purchase or the
pump serial number).
This guarantee is in addition to your statutory rights as a consumer. If you are in any
doubt as to these rights, please contact your local Trading Standards Department or
Citizen’s Advice Bureau.
GOOD PRACTICE
Always flush system prior to installing a new or serviced pump.
Always ensure the pump is primed (filled with water) before starting. DO NOT RUN
PUMP DRY.
Always ensure the pump has a minimum flooded suction head of 1 metre at all times.
Always ensure anti-vibration feet are used.
Ensure pump is sited in dry ventilated position.
Do not allow pump to freeze.
Abide by the Water Supply (Water Fittings) Regulations 1999.
Always install isolating valves to both suction and delivery pipework.
Ensure earth continuity between suction and delivery pipes.
Always ensure pump wiring conforms with the current national electrical regulations and
is installed by a competent person.
Do not install a non-return valve, or devices which
contain non-return valves, in the suction (inlet) pipework
to the pump. The pump must be free to vent to the
supply tanks at all times.
Disconnect electrical supply before working on pump or motor.
Carefully check pump and pipework for leaks before leaving the installation unattended.