PreSonus DEQ624 - Manual (Page 16)

CONTROLS & CONNECTIO NS
14
The following example illustrates enabling and disabling HI Q for the 1kHz EQ
encoder for Channel A.
EXAMPLE
Enabling HI Q for 1 kHz (Channel A)
(HI Q is not enabled for any of Channel A’s EQ encoders at the start of the
sequence).
1. Press the Channel A HI Q switch. The Channel A switch lights up and
none of the HI Q Active LED’s in the Graphic Equalizer section are lit.
2. Move the Channel A 1 kHz EQ encoder quickly. This will start the HI Q
Active LED beneath the 1 kHz EQ encoder of Channel A and the Store /
Security switch light to begin blinking slowly.
3. Press the Store / Security switch. The HI Q Active LED below the 1 kHz
remains on continuously and the Store / Security switch light goes OFF.
The 1 kHz EQ encoder is now in HI Q.
4. Pressing the Channel A HI Q switch turns off both the HI Q switch light
and the HI Q Active LED indicator beneath the Channel A 1 kHz EQ
encoder. The resulting HI Q Boost / Cut of the Channel A 1 kHz EQ
encoder remains.
Disabling HI Q
(The sequence begins with only the 1 kHz EQ encoder of Channel A HI Q
enabled.)
1. Start by engaging the Channel A HI Q switch. The HI Q switch and the HI
Q Active LED indicator below the 1 kHz EQ encoder of Channel A light
up and remain ON.
2. Next, move the 1 kHz EQ encoder of Channel A quickly. This will cause
the HI Q Active LED indicator below the 1 kHz EQ encoder of Channel A
and the Store / Security switch to blink rapidly.
3. Pressing the Store / Security switch results in the HI Q Active LED
indicator below the 1 kHz EQ encoder of Channel A and the Store /