PreSonus FIREstation - Manual (Page 8)

2
2.1 BASIC SETUP & APPLICATIONS
2.2 Computer Setup
Place the provided driver’s software in your computer after powering it
up. If an install wizard appears, direct it to the provided CD-ROM when
prompted. If the install wizard does not appear, open the CD-ROM and
run the Auto Installer from there. Follow the directions on your screen.
NOTE: It is essential that the FIREstation not be connected to the
computer when the drivers are installed. If you accidentally leave the
FIREstation connected, disconnect the unit, uninstall the drivers,
reboot and then reinstall the drivers.
After the driver fully installs power down your computer. Turn off all
external devices before connecting the FIREstation(s). Connect all
external devices to the FIREstation(s). Power up the FIREstation and
then connect the FIREstation to the computer using the provided 6-pin
FireWire cable. Fasten your seatbelt and then power up the computer.
Three different items will be loaded on your computer at this point.
The first item that is loaded is the actual software driver. The driver
allows your computer to recognize and communicate with the
FIREstation. A control panel is also loaded. The control panel indicates
if the FIREstation is connected properly. It also indicates and helps
control sample rate and clock control (sync). A patchbay is also
loaded. The patchbay allows the user to route the inputs and outputs
of the FIREstation in computer. It is important to note that each
FIREstation has a unique Identity. So, if a FIREstation is connected
and routed, that routing scheme that is saved will only work for that