PreSonus V-Fire - Manual (Page 17)

5 ROLAND VS SETTINGS
17
Input to VS-2400CD
Press the EZ ROUTING and press F1 for View.
At the top of the screen, attach up to 8 input mixer channels to 8 R-Bus inputs, using the
cursor buttons and TIME/VALUE wheel.
Raise the appropriate input mixer channel faders to monitor the incoming audio signals.
Note: R-Bus is routed to Input Mixer channels 9-16 by default.
Output from VS-2400CD
Press the EZ ROUTING button.
Press the PAGE button until you see Output over the F3 button.
Press F3 for Output.
Cursor to Track Direct, and use the TIME/VALUE wheel to turn Track Direct ON.
Cursor to the R-Bus Outputs and use the TIME/VALUE wheel to connect the R-Bus output
pairs at the top of the screen with the Track Numbers down the right side of the screen.
This will route individual VS-2400CD audio track outputs to the V-Fire inputs via R-Bus.
Alternatively,
Leave Track Direct OFF and connect the R-Bus output pairs on the top of the screen to Auxes,
Directs, or Busses of your choice, using the TIME/VALUE wheel.
Roland VS-2400CD, Using a VGA Monitor
Digital Clock (Slave)
From the Utility menu, select Project Parameter.