Nexo STM Series - Manual (Page 8)

8
DISMANTLING
De-rigging
De-rigging is as simple as following rigging procedures in reverse order:
•
Lower the array slowly, until the array is close to the floor.
•
Release compression slowly, until the array is hanging vertically.
•
Remove the compression chain, BTCOUP2/3 if required, and BTBUMPERs.
•
Remove all speaker cables within reach, without climbing the array.
•
Set all piston taps to the STORAGE position.
•
Position dollies below the bottom module and lock the wheel brakes.
•
Lower the arrray into position on the dollies.
•
Push REDLOCK to LOCK position on the bottom cabinets.
•
Release the upper array from the stacked cabinets by releasing the REDLOCK and the
rear steel pin on the cabinet above the stacked boxes.
•
Lift remaining array, release wheel brakes and remove stacked modules.
•
Repeat as required.
•
Remove rigging components.