Renkus-Heinz STXLA/9 - Manual (Page 6)

Line Array User’s Manual Line Array User’s Manual
Thank you for selecting a Renkus-Heinz Line Array System. This manual is intended to help you obtain optimum
performance from your system. Your system is one of the four types described below and on the next page.
PN/PNX SY PN/PNX SY PN/PNX SY PN/PNX SY PN/PNX SYSTEMS STEMS STEMS STEMS STEMS
PN102/LA SYSTEMS
PN102/LA Self-Powered Line Array Module. 2x 10" LF drivers with Midrange Acoustic Diffraction Baffles and two
1" exit HF drivers on an Isophasic Plane Wave Generator. Engineered for use in vertical arrays; integral two-point
flying hardware. Self-powered with the PN-1 PowerNet amplifier: R-Control optional.
PNX102/LA SYSTEMS
PNX102/LA Line Array Module. Designed for bi-amp power with external amplifiers using X-Series analog or
D26 digital controllers for Loudspeaker Specific Processing and protection. Uses the same components and
pattern control technologies as the self-powered PN102/LA module.
The PNX102LA uses 16 Ohm LF and 16 Ohm HF driver configurations. This enables a single amplifier to drive
a number of array modules.
ALL PN102/LA & PNX102/LA SYSTEMS
RHANG/LA Fly Bar. Coupled with the two-point angle-setting system on Renkus-Heinz Line Array modules,
it provides a safe, flexible and simple means of flying vertical arrays up to12 deep.
RHANG/LA Tie Bars and Quick-Disconnect pins provide a choice of splay angles and metal-to-metal reliability.
102Dolly holds up to 4 PN102/LA or PNX102/LA modules.
PN102/LA & PNX102/LA
Have one operator stabilize the dolly-stacked modules, then raise the array until the tie bars are free of the receiving
tubes.
Roll the dolly and the stack of modules out of the way and repeat the process until the entire array has been stacked on
dollys.
Remove the shackles from the RHANGSLTA fly bar
6 27