SABINE FBX-SOLO SL820 User Manual
Page 15
15
Slowly raise the input
channel level fader for
the channel being set
until feedback occurs.
The SOLO should
quickly remove the feed-
back.
The first Filter LED will then blink
to indicate a filter has been set.
Keep raising the level slowly
until all Fixed Filters and one
Dynamic filter is set. Turbo Setup
Mode goes OFF automatically
when the first Dynamic filter is
initialized. Any un-initialized Dy-
namic filters will be set later if
feedback occurs during the pro-
gram.
You can limit the total number of
filters in use by pressing the
Lock Fixed button before setup
is automatically ended.
Now lower the channel level fader
slightly so that the system is not
on the verge of another feedback
point. This is the maximum vol-
ume level that the FBX-SOLO
will be able to provide. Higher
levels will cause uncontrollable
feedback.
Finally, during sound check, ad-
just the Clip Level Adjust so that
the red Clip LED blinks intermit-
tently, as you would adjust the
recording level of a tape recorder.
The unit will clip and distort the
program if the Clip Level Adjust is
set too high. If it is set too low,
the signal-to-noise ratio will de-
grade and the system may hiss.
CHANNEL
INPUT
LEVEL
FIRST FEEDBACK
TONE
CHANNEL INPUT
LEVEL
FEEDBACK
TONES
CHANNEL INPUT
LEVEL
7
8
9
IMPORTANT: Make sure Turbo mode is OFF —
Clip LED NOT flashing!