ReadyLIFT Dodge Ram 1500: 2006-2014 4WD - 2.0 T6 Billet" User Manual
Page 4
.
Upon completion on the last step take note
that the strut assembly must be installed 180
degrees from it’s original orientation. Attach
the strut assembly with the new hardware
provided and tighten to spec. Then perform
the previous steps in reverse order. Double
check your work and torque all hardware and
components to factory or specified torque
settings.
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions (66-1030, T6-1030)
Using a pry bar, release tension, remove upper ball joint nut.
Gently tap lower strut mounting bolt out.
From opposite side remove bolt
Mark and loosen front/rear lower control arm alignment cams
Push down suspension while lifting strut fork over lower arm.
Then, lower strut out of frame and remove from vehicle.
Install new strut extension onto OE strut with OE hardware.