Bolt size millimeters, Bolt size sae, Vehicle ride height chart – ReadyLIFT Toyota Tundra 2007-2014, 2WD/4WD - 2.4 T6 Billet Leveling Kit" User Manual

Page 2

Advertising
background image

Bolt Size

Millimeters

Torque Specs in FT/LB

Metric Grade

8.8

Metric Grade

10.9

6mm

6

8

8mm

16

22

10mm

40

45

12mm

54

70

14mm

89

117

16mm

132

175

18mm

182

236

Bolt Size

SAE

Torque Specs in FT/LB

Grade 5

Grade

8

5/16

15

20

3/8

30

35

7/16

45

60

1/2

65

90

9/16

95

130

5/8

135

175

3/4

185

280

Please read Instructions thoroughly and completely before beginning installation.

Installation by a certified mechanic is recommended.

ReadyLIFT Suspension Inc. is NOT responsible for any damage or failure resulting from improper installation

.

Safety Warning: Suspension systems or components that enhance the on and off-road performance of your vehicle

may cause it to handle differently than it did from the factory. Extreme care must be used to prevent loss of control or

vehicle rollover during abrupt maneuvers. Always operate your vehicle at reduced speeds to ensure your ability to con-

trol your vehicle under all driving conditions. Failure to drive safely may result in serious injury or death to driver and

passengers. Driver and passengers must ALWAYS wear your seat belts, avoid quick sharp turns and other sudden ma-
neuvers. ReadyLIFT Suspension Inc. does not recommend the combined use of suspension lifts, body lifts, or other

lifting devices. You should never operate your vehicle under the influence of alcohol or drugs. Constant maintenance is

required to keep your vehicle safe. Thoroughly inspect your vehicle before and after every off-road use.

Installation Warning: All steps and procedures described in these instructions were performed while the vehicle was

properly supported on a two post vehicle lift with safety jacks. Use caution during all disassembly and assembly steps
to insure suspension components are not over extended causing damage to any vehicle components and parts included

in this kit. Included instructions are guidelines only for recommended procedures and are not meant to be definitive.

Installer is responsible to insure a safe and controllable vehicle after performing modifications.

ReadyLIFT Suspension Inc. recommends the use of an OE Service Manual for model/year of vehicle when disassembly

and assembly of factory and related components. Unless otherwise specified, tighten all bolts and fasteners to standard
torque specifications listed within the OE Service Manual, or as referenced in the torque specification list provided in

these instructions.

Suspension components that use rubber or urethane bushings should be tightened with the vehicle at normal ride

height. This will prevent premature wear or failure of the bushing and maintain ride comfort. Larger tire and wheel

combinations may increase leverage on suspension, steering, and related components. Due to payload options and ini-
tial ride height variances, the amount of lift is a base figure. Final ride height dimensions may vary in accordance to

original vehicle ride height. Always measure the vehicle ride height prior to beginning installation.

Vehicle ride height chart

Driver Front:

Stock height

Lift installed

Driver Rear:

Stock height

Lift installed

Pass. Front:

Stock height

Lift installed

Pass. Rear:

Stock height

Lift installed

Advertising