ReadyLIFT GMC Denali 1500 SST Lift Kit, 2007-2014, 4WD 6-lug - 4.0F/3.0"R" - Manual (Page 12)

www.ReadyLIFT.com - Phone: (800) 549-4620
Installation Instructions (69-3285, 69-3295, 69-3485, 69-3495)
12
Revised Feb-2014
Reinstall the wheels & tires and lower to the
ground. Re-check all work performed, check for
proper clearance at full turn and while in re-
verse.
ANY CONTACT BETWEEN TIRE AND
UPER CONTROL ARM WILL CAUSE PREMA-
TURE FAILURE OF THIS KIT. Torque all
hardware to spec. Test drive and re-torque u-
bolts and wheels. the vehicle MUST be properly
aligned to validate warranty.
Re-install the isolators and coil springs and raise axle. Re-install the shocks with extensions as shown and tighten.
Install the new longer sway bar end links and tighten.
71.
70. 69.
WARNING TO END USER, INSTALLER AND SELLER OF
THIS PART!
By installing this part you are accepting full responsibility and liability
for proper wheel and tire fitment after installation.
It is the installer’s responsibility to properly align the vehicle before use. Using a wheel tire fitment combination that results in any
contact from the tire and/or wheels with the new installed ReadyLIFT® upper control arm or inner fenders at any point including
full steering lock will void the ReadyLIFT® warranty and may result in failure of the ball joints. Failure to do so may cause damage
to your vehicle and/or injury or death to the driver and passengers.
Final Checks & Adjustments
Post Installation Warnings: Once the vehicle is lowered to the ground, check all parts which have rubber or urethane compo-
nents to insure proper torque. Torque wheels to factory specs. Move vehicle backwards and forwards a short distance to allow
suspension components to adjust. Turn the front wheels completely left then right and verify adequate tire, wheel, brake line,
and ABS wire clearance. Test and inspect steering, brake and suspension components for tightness and proper operation. In-
spect brakes hoses and ABS lines for adequate slack at full extension. Failure to perform the post inspection checks may result in
vehicle component damage and/or personal injury or death to driver and/or passengers and void your warranty. Test drive vehi-
cle and re-check the torque of all fasteners and re-torque wheels on vehicle. Vehicle Handling Warning: Vehicles with larger
tires and wheels will handle differently than stock vehicles. Take time to familiarize yourself with the handling of your vehicle.
Wheel Alignment/Headlamp Adjustment
It is mandatory to have a proper and professional wheel alignment performed by a certified alignment technician.
Align the vehicle to factory specifications. It is mandatory that your vehicle alignment be checked after any off-
road driving. In addition to your vehicle alignment, for your safety and others, it is necessary to check and adjust
your vehicle headlamps for proper aim and alignment.
Vehicle Re-Torque and Safety Inspection
Upon completion of all services and adjustments performed on your vehicle, and within 50 miles of driving, check
to ensure all fasteners and hardware are properly torqued to specification as noted in the vehicles factory service
manual or the torque chart included.