ReadyLIFT Toyota Tacoma 5-Lug SST Lift Kit, 2005-2014, 2WD - 2.75F/1.75"R" - Manual (Page 2)

ReadyLift® (Part# 69-5510) Installation Instructions
2005-2008 Toyota Tacoma 2WD 5 Lug (Install Video Online at ReadyLift.com)
ReadyLift Suspension Inc.
3201 W MacArthur Blvd, Santa Ana, CA, 92704
T o l l F r e e ( 8 8 8 ) 9 2 2 -2 2 9 4 L o c a l ( 7 1 4 ) 8 6 2 - 2 9 6 8 F a x ( 7 1 4 ) 8 6 2 - 2 9 7 2
9 / 1 8 / 2 0 0 8
Using a high speed cut off tool, remove 1/2” off
the long stud located on the top of the strut.
Before cutting, make sure that the nut is
threaded on the stud. It will re-thread the
stud after cutting it.
Install ReadyLift® strut
extension. Torque to factory specs.
Rotate the top of the strut 120 degrees so that when you install it the bracket on the bottom of
the strut is on the is back in the stock location.
Install but do not tighten the three upper nuts.
Use a jack to raise the lower control arm and install the lower strut mounting bolt.
Reverse steps 1-3. Be sure to apply thread locker where needed. Repeat on other side.
Once front kit is complete and wheels installed, lower the vehicle back down on the ground.
Align the markings made on the alignment cams to the markings made on the flange and
torque to factory specs. Make sure that all hardware gets torqued to factory specs.
4.
5.
Part Tightened Torque ft.lb
Front and Rear Wheels 83
Upper strut mounting nuts 47
Lower strut mounting nut 61
Brake line bracket @ strut 24
ABS bracket bolt @ UCA 44 in. lb ft
ABS bracket @ Knuckle 44 in. lb ft
Upper control arm bolts 60
Lower control arm 155
U-bolts 37
E-brake bracket bolt 9
Leaf spring eye bolts 89
Rear shock lower mount nut 74
Rear shock upper mount 15