ReadyLIFT Toyota Tacoma Prerunner - SST Lift Kit: 2012-2014, 2WD/4WD - 2.75-3.0F/2.0"R" - Manual (Page 6)

www.ReadyLIFT.com - Phone: (800) 549-4620
Installation Instructions 69-5212
6
Final Checks & Adjustments
Post Installation Warnings: Once the vehicle is lowered to the ground, check all parts which have
rubber or urethane components to insure proper torque. Torque wheels to factory specs. Move vehicle
backwards and forwards a short distance to allow suspension components to adjust. Turn the front
wheels completely left then right and verify adequate tire, wheel, brake line, and ABS wire clearance.
Test and inspect steering, brake and suspension components for tightness and proper operation. In-
spect brakes hoses and ABS lines for adequate slack at full extension. Failure to perform the post in-
spection checks may result in vehicle component damage and/or personal injury or death to driver and/
or passengers. Test drive vehicle and re-check the torque of all fasteners and re-torque wheels on ve-
hicle. Re-adjust headlamps.
Vehicle Handling Warning: Vehicles with larger tires and wheels will handle differently than stock
vehicles. Take time to familiarize yourself with the handling of your vehicle
.
Wheel Alignment/Headlamp Adjustment:
It is necessary to have a proper and professional wheel alignment performed by a certified
alignment technician. Align the vehicle to factory specifications. It is recommended that
your vehicle alignment be checked after any off-road driving. In addition to your vehicle
alignment, for your safety and others, it is necessary to check and adjust your vehicle
headlamps for proper aim and alignment
Vehicle Re-Torque and Safety Inspection:
Upon completion of all services and adjustments performed on your vehicle, and within 50 miles of driv-
ing, check to ensure all fasteners and hardware are properly torqued to specification as noted in the
vehicles factory service manual or the torque chart included.
REAR-BLOCK INSTRUCTIONS
1. DO NO STACK BLOCKS AS IT IS DANGEROUS
TO YOU AND OTHERS, AND IS ILLEGAL IN MOST
STATES. Rear Block Installation
Remove the four 19mm nuts and two u-bolts from one
side of the vehicle.
2. Using a jack and a block of wood, carefully
raise the truck by the leaf spring until there is
enough room for the new block. Install the
ReadyLift® 2” rear block.
Lower the jack and make sure that the leaf
spring center pin goes into the hole on top of
the block.
Install ReadyLift® u-bolts using the hardware
provided. Torque to 120 ft/lbs. Repeat on
opposite side.