ReadyLIFT Honda Pilot, 2003-2008, 2WD & 4WD, 2.0F/1.0"R" User Manual
Page 2
ReadyLift
®
(Part# 69-8010)
2003-2008 Honda Pilot FWD/4WD Installation Instructions
2”Front/2” Rear
Revised
5-6-09
ReadyLift Suspension, Inc.
3201 W. MacArthur Blvd, Santa Ana, CA, 92704
T o l l F r e e ( 8 8 8 ) 9 2 2 - 2 2 9 4 Fa x 7 1 4 -8 6 2 -2 9 7 2
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any installation instruction updates
Installation by a trained mechanic is recommended.
Bill of Materials
Description Qty
Driver side strut extension, front
Passenger side strut extension, front
Sway bar end link, front
M10 x 1.25 flange nut
1.25” coil spacer, rear
Adjustable camber arm, rear (67290)
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground.
Use a minimum 3 ton jack stands and place under frame for safety or a (2) two post lift if available.
Make sure that the emergency brake is on and the rear wheels are blocked to prevent a rollout.
1.
3. 4.
2.
Open the hood and set at highest setting. Remove the
front wheels. Starting on the driver side.
Use a flat screwdriver to remove windshield wiper ac-
cess panels . Remove the three 14mm upper strut nuts.
Remove the brake line support bracket using a 12mm
wrench.
Use a 10mm wrench and remove the ABS line support
bracket bolt.
1
1
2
6
2
2