STI AP-1-G-I - Manual (Page 2)

- 2 -
Installation of the unit
1. Mounting Plate Orientation 2. Attach Mounting Plate
3. Attach the Chassis
4. Attach the Front Cover
Basic operations
1. Turn the Unit “ON” 2. Test the Unit
3. Reset the Unit
4. Removing the Front Cover
Using the 2 pips on the
reset key provided, push
firmly into each of the 4
corner clips individually,
releasing them, while at the
same time, gently pulling
the cover away from the
mounting plate.
The reversible
mounting plate
can be installed
in any orientation;
depending on the
required conduit
entry and exit points.
PILOT POINT
x 2
FIXING CLIP
Mark the 4 fixing
points (as shown)
and install using
the screws and
Rawlplugs provided.
FIXING
POINTS x 4
Note: Consult
Programmable
Features section
prior to Front Cover
Installation. Line up
each end using the
channels located on
the raised conduit
sections (see detail)
then push evenly until
the cover locks into
place via 4 raised
mounting clips situated
on each corner.
MOUNTING
CLIPS
PILOT POINT
x 1
Attach by pushing
the chassis over
the 4 fixing clips on
the mounting plate
(highlighted).
Using the master key,
turn the key switch
cylinder to the vertical
position.
Insert the reset key
into the bottom of the
Alert Point:Lite. A quick
counter-clockwise turn
of the key and the unit
is reset, returning to
“standby” condition and
is ready for use.
Depress the
operating element.
A warning indicator
drops into view, the
unit will alarm.