Anthro eNook Standard II Assembly Instructions - Manual (Page 6)

6 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
steP 11
install Four Fasteners onto main unit
¡ Using your Hex Driver, install two black
Workstation Screws onto the side walls, but
don’t tighten all the way. Stop tightening
when the screw head is about 1/4" from tight.
workstation screw
325-5092-00
steP 12
Attach main unit to Frame
¡ Open the top and bottom doors and
find the angle slots on the Frame.
¡ Lift the Main Unit onto the Frame by
aligning the two Workstation Screws
on the Frame with the angle slots.
Make sure that both fasteners are
captured.
¡ Using a 5/32" hex driver, tighten
down the workstation screws.
steP 10
insert screw and install Frame
¡ Insert one 1-5/8" long screw into the top two TOGGLERs, but don’t tighten all the way. Leave the screw head about
1/4" from the plastic cap.
¡ Lift the Frame onto the top two screws. Install the bottom two screws, then tighten down all four screws.