Boltek EFM-INV3 - Manual (Page 5)

10/10/2012
(C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2
Assembling the pole mount bracket
(Skip this page if using INV2 or INV3 kit)
Remove nuts and washers from the two U-Bolts and place around inverted mast. Secure bolts
to bracket as shown below
Open hose clamps, and hold bracket against pole. Place hose clamps through bracket and
tighten around pole. Recommended pole size is between 2.5" and 4" outer diameter. If a larger
pole is used, bigger hose clamps can be purchased at a local hardware store.